At present, PVDF color-coated board is widely used in the industrial industry, construction industry, and electrical appliance industry. Of course, it has the advantages of corrosion resistance, energy saving and environmental protection, etc., and has won a broad market and a good reputation. Let's talk about the precautions for PVDF color-coated boards?

When using PVDF color-coated plate, you need to pay attention to the vertical transportation of the panel, and then ensure that the mother rib is facing the installation method, install a row of fixing brackets, fix the purlins on the roof, adjust its position, ensure that the position of the top plate is accurate, and fix a row of fixing brackets. At this time, a color-coated plate can be placed on the fixing bracket in a direction perpendicular to the gutter, align the middle rib with the corner of the fixing bracket, and put foot tendons or wooden purlins on the middle rib. The mother rib buckle is on the top of the fixing bracket, and then check whether it is fully buckled. Next, fix the fixing bracket on the male ribs of the pre-installed painted board and install it on each bracket. Use the second row of fixing brackets to fix the female ribs of the PVDF color-coated board from the middle to both ends, and then install the color-coated board in the same way. Pay attention to fixing and reliable connections, and check the straightness of the roof at the gutter, the verticality of the gutter and other positions at any time. Or you need to use a positioning line at the end of the board to ensure the parallelism of the PVDF color-coated board itself and the verticality of the gutter during the installation process.

Also note when using PVDF color-coated panels is that the top of the purlin used for support must be on the same plane. According to the actual situation, its position can be adjusted by tapping or slack to meet this requirement. At this time, it is recommended not to directly click on the bottom of the fixing bracket to adjust the slope or position of the roof, and place the color-coated panel correctly to ensure its effective tightening. On the contrary, if the color-coated panel is not properly aligned when placed, it will affect the tightening effect of the color-coated panel, especially the part near the midpoint of the bracket. Of course, in the later stage, in order to avoid the color-coated plate fanning or spreading due to improper construction, or making the lower edge of the roof uneven, it is necessary to always check whether the PVDF color-coated plate is aligned in place. When placing the color-coated plate, measure the color-coated plate at any time. Whether the distance from the upper and lower edges of the plate to the gutter is equal. To prevent the PVDF color-coated plate from tilting. Therefore, it is necessary to clean up the residual water debris, rivet rods, waste fasteners and other metal debris on the roof immediately after installation. Because these metal debris will cause corrosion to the color-coated plate.

The content of the above article is the precautions for PVDF color-coated boards told by friends. If you have this demand, you can check it out, hoping to help you. As the main product of our factory, thanks to the strong support of new and old customers, we not only ensure the reliability of product quality, but also benefit our customers. If you have relevant technical questions about the product, you can come here for consultation at any time.